ProSoft Technology ProLinx S3964R Manual de usuario descargar pdf (Pagina 28)

MVI69-S3964R ♦ CompactLogix or MicroLogix Platform Configuring the MVI69-S3964R Module

Siemens 3964R Protocol

Page 28 of 80 ProSoft Technology, Inc.

October 31, 2008

2.4.8 Use CTS Line

Yes or No

This parameter specifies if the CTS modem control line is to be used. If the

parameter is set to No, the CTS line will not be monitored. If the parameter is set

to Yes, the CTS line will be monitored and must be high before the module will

send data. Normally, this parameter is required when half-duplex modems are

used for communication (2-wire).

2.4.9 Swap

0 or 1

This parameter specifies whether bytes should be swapped. 0 = No data byte

swapping, 1 = Data byte swapping.

2.4.10 Priority

0 or 1

This parameter specifies whether the data is high priority or low priority. 0 = High

priority, 1 = Low Priority.

2.4.11 Protocol

0 or 1

0=3964 RK512, 1=3964

2.4.12 ACK Delay

Number of milliseconds to wait for ACK. The default is 1000 ms.

2.4.13 Setup Attempts

Number of times to try to connect to CP (Default 6)

2.4.14 Transmit Attempts

Number of times to try to transmit to CP (Default 6)

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 79 80

Sin comentarios

ProSoft Technology ProLinx S3964R Manual de usuario Pagina 28