ProSoft Technology RLXIC-EH Manual de usuario descargar pdf (Pagina 37)

Universal Serial Bus (USB) RLXIC-EH ♦ Intelligent Cellular

User Manual RadioLinx Intelligent Cellular Ethernet Gateway for HSUPA (3G GSM) Networks

ProSoft Technology, Inc. Page 37 of 111

May 29, 2009

6 Universal Serial Bus (USB)

In This Chapter

 Changing the USB port communication ................................................37



Installing the USB driver........................................................................38

 Using the Virtual Ethernet Port..............................................................45



Using the Virtual Serial Port ..................................................................46

The RLXIC-EH is equipped with a USB port which increases the methods by

which you can send and receive data. The USB port can be set to work as either

an Ethernet port or a virtual serial port. A driver installation is required to use the

USB port in either mode.

Note: It is recommended that you use a USB 2.0 cable with your RLXIC-EH and connect directly to

your computer for best throughput.

6.1 Changing the USB port communication

The command to change the port configuration is *USBDEVICE, and it is in the

USB group of AceManager.

By default, the port is set to work as a virtual Ethernet port (*USBDEVICE=1).

To change the USB port to allow virtual serial port communication, disable the

Ethernet port emulation, set *USBDEVICE to 0.

Note: If you use a terminal connection with the USB port to change *USBDEVICE, the change is

immediate. Your connection will be terminated after inputting the command.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 110 111

Sin comentarios

ProSoft Technology RLXIC-EH Manual de usuario Pagina 37