Prosoft-technology MVI69-ADMNET Manual de usuario descargar pdf (Pagina 39)

MVI-ADMNET ♦ 'C' Programmable Setting Up Your Development Environment

'C' Programmable Application Development Module with Ethernet Developer's Guide

ProSoft Technology, Inc. Page 39 of 122

February 20, 2013

3.4 Downloading a ROM Disk Image

3.4.1 MVIUPDAT

MVIUPDAT.EXE is a DOS-compatible utility for downloading a ROM disk image

from a host PC to the MVI-ADMNET module. MVIUPDAT.EXE uses a serial port

on the PC to communicate with the module. Follow the steps below to download

a ROM disk image:

1 Connect a null-modem serial cable between the serial port on the PC and

PRT1 on the MVI module.

2 If you are using HyperTerm or a similar terminal program for the MVI-

ADMNET module console, exit or disconnect from the serial port before

running the MVI Flash Update tool.

3 Turn off power to the MVI module. Install the Setup Jumper as described in

the Installation Instructions.

For DOS:

1 Click the START button, and then choose RUN.

2 In the OPEN: field, enter MVIUPDAT. Specify the PC port on the command line

as shown in the following illustration. The default is COM1.

3 Turn on power to the MVI module. You should see the following menu shown

on the host PC.

+----------------------------+

| Main Menu |

|----------------------------|

| Verify Module Connection |

| Update Flash Disk Image |

| Reboot Module |

+----------------------------+

4 Select VERIFY MODULE CONNECTION to verify the connection to the MVI

module. If the connection is working properly, the message "Module

Responding" will be displayed.

Note: If an error occurs, check your serial port assignments and cable connections. You may also

need to cycle power more than once before the module responds.

5 Select UPDATE FLASH DISK IMAGE to download the ROM disk image. Type the

image file name when prompted. The download progress is displayed as the

file is being transmitted to the module.

6 After the disk image has been transferred, reboot the MVI module by

selecting the REBOOT MODULE menu item.

7 Exit the MVIUPDAT.EXE utility by pressing [ESC].

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 121 122

Sin comentarios

Prosoft-technology MVI69-ADMNET Manual de usuario Pagina 39