Prosoft-technology AN-X-PB Manual de usuario descargar pdf (Pagina 12)

Page

AN-X-PBCAPT November 2011

1. Select the Ethernet adapter that’s connected to the AN-X. In most

cases there will be just one Ethernet adapter in the computer. The AN-X

must be on the same subnet as the computer.

2. Enter the MAC address of the AN-X you are configuring. This is

printed on the AN-X label. It consists of six pairs of hexadecimal digits,

separated by hyphens. In the example above, it’s 00-0c-1a-00-00-09.

If the AN-X is already online, you can obtain its MAC address using the

Utilities/Locate All AN-X Modules command.

3. Enter the IP address you intend the AN-X to use.

Step 2

In step 2, you choose a method of restarting AN-X to put it in boot mode.

The preferred method is to cycle power on the AN-X. Select the first

option on the screen and click the Next >> button.

The second method, useful if the AN-X in not easily accessible, is to

send it a command over Ethernet. The AN-X must be powered on and

completely running for this method to work. For example, if this is the

first time you are configuring a new AN-X, allow sufficient time for it to

acquire an IP address from a DHCP server or to time out and use its

default IP address (about 3 minutes). Select the second option on the

screen and click the Next >> button.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 60 61

Sin comentarios

Prosoft-technology AN-X-PB Manual de usuario Pagina 12