Prosoft-technology AN-X2-SQD Manual de usuario descargar pdf (Pagina 11)

AN-X2-SQD-MAS Page 5

Pin Assignment

1 RIO 2

2 RIO 1

3 shield

4 RIO 4

5 RIO 3

Ensure that the physical ends of the remote I/O network are properly terminated. The

AN-X module does not have any internal termination.

A Square D scanner has a 220 ohm resistor built in across RIO1 & RIO2 (rx). Since the

AN-X does not have a built-in terminator, add a 220 ohm resistor externally if it is being

used as a scanner.

Square D adapters connect a 220 ohm resistor across RIO3 & RIO4 when the switch is

turned on. If the AN-X is a monitor, add a 220 ohm resistor if it is at the end of the

network, and shut off the switch for the node that was previously at the end.

Ethernet Cabling

AN-X has a standard RJ-45 connector for connecting to Ethernet.

If you are connecting to the AN-X through a router or switch, use a standard Ethernet

cable.

If you are connecting directly to the AN-X module, use a crossover cable.

Software Installation

There is no required software installation for the AN-X2-SQD-MAS. All configuration

is done using the web interface.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 50 51

Sin comentarios

Prosoft-technology AN-X2-SQD Manual de usuario Pagina 11