Prosoft-technology AN-X2-SQD Manual de usuario descargar pdf (Pagina 46)

Page 40 AN-X2-SQD-MAS June 2013

“Railroading” – SYS (or MS) and NET (or NS) LEDs

AN-X alternates (railroads) flashing the SYS (or MS) and NET (or NS) LEDs to indicate

its state.

It railroads the LEDs yellow while it is copying new maintenance or production firmware

files from the microSD card to flash memory.

It railroads the LEDs green for 20 to 30 seconds as it starts production mode.

MS and NS LEDs: Runtime

IMPORTANT!

There are two possible runtime LED modes.

Standard mode is the new default mode and is compliant with the

Ethernet/IP specification.

Debug mode provides more information about the state of the remote I/O

network.

To set debug mode, enter a line with the keyword LedModeDebug in the ControlLogix

configuration file.

When you autoconfigure the AN-X, it sets debug mode in the file it creates.

IMPORTANT!

The AN-X enters debug mode only if the ControlLogix configuration

succeeds.

Standard Mode

The MS and NS LEDs are used by the AN-X operating system and software to indicate

the state of operations and errors.

In standard mode, the MS and NS LEDs should be used in conjunction with the logs to

locate the cause of problems.

Condition LEDs

All OK MS Solid Green, NS Solid Green

Missing connections MS Solid Green, NS Flashing Green

Error event MS Solid Green, NS Pulses Red

Bad Config MS Flash Red, NS Flash Green

Error Events:

- Connection Timeout

- Returned error to connection request

1 2 ... 41 42 43 44 45 46 47 48 49 50 51

Sin comentarios

Prosoft-technology AN-X2-SQD Manual de usuario Pagina 46