Prosoft-technology AN-X-AMX Manual de usuario descargar pdf (Pagina 37)

AN-X-AMXCAPT Page 33

Read Kernel Parameters

The Utilities/Read Kernel Parameters command displays various communications

parameters for the currently selected AN-X

This command resets the AN-X. You will be warned and given the opportunity to cancel

the command.

The Utilities/Read Kernel Parameters command leaves the AN-X running the boot code.

Use the Utilities/Restart AN-X command to restart the AN-X in production mode.

Run Config Mode

The Utilities/Run Config Mode command is used to restart the currently selected AN-X

in configuration mode (normally used internally for updating firmware).

This command is not used in normal operation but may be required for technical support.

The AN-X is in configuration mode when the SYS LED flashes red twice, followed by a

pause.

To exit configuration mode, use the Utilities/Restart AN-X command to restart AN-X in

production mode.

Update AN-X Flash

The Utilities/Update AN-X Flash command updates the low-level firmware (boot code,

configuration kernel, production kernel).

Files have extension qtf.

This command resets the AN-X. You will receive a warning and be given the

opportunity to Cancel the command.

If you cancel at the filename dialog, the AN-X has already been reset and is in boot

mode. Use the Utilities/Restart AN-X command to restart it in production mode.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 49 50

Sin comentarios

Prosoft-technology AN-X-AMX Manual de usuario Pagina 37