
Reference DFNT ♦ ProLinx Gateway
Protocol Manual EtherNet/IP Explicit Messaging Client/Server
Page 74 of 124 ProSoft Technology, Inc.
July 24, 2013
This function sets or resets individual bits within a limited area of the PLC data
table. This function should work on the following devices: 1774-PLC, PLC-2,
PLC-3 and PLC-5.
5.2.5 Function Code #5 - Unprotected Write (Basic Command Set)
0=Disabled, 1=Continuous and 2=Conditional.
This parameter defines the database address of the first
data point to be associated with the command.
Minimum time in tenths of a second to wait before
polling with this command.
Number of data word values to be considered by the
function.
Swap type code for command: 0=None, 1=Swap words,
2=Swap words & bytes and 3=swap bytes in each word.
Address of unit to reach on the data highway.
Processor slot number in Control/CompactLogix rack.
Use -1 for PLC5 & SLC processors.
Unprotected Write Function
Word address where to start the write operation.
These fields are not used by the command. Values
entered in these columns will be ignored.
This function writes one or more words of data to the PLC memory. This function
should work on the following devices: 1774-PLC, PLC-2, PLC-3, PLC-5, SLC
500, SLC 5/03, SLC 5/04 and MicroLogix 1000.
Comentarios a estos manuales