Prosoft-technology MVI69-DNP Manual de usuario Pagina 12

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 129
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 11
MVI69-DNP CompactLogix or MicroLogix Platform Start Here
DNP 3.0 Master/Slave Communication Module
Page 12 of 129 ProSoft Technology, Inc.
November 3, 2008
1.4 Install the Module in the Rack
This section describes how to install the module into a CompactLogix or
MicroLogix rack
Before you attempt to install the module, make sure that the bus lever of the
adjacent module is in the unlocked (fully right) position.
Warning: This module is not hot-swappable! Always remove power from the rack before
inserting or removing this module, or damage may result to the module, the processor, or other
connected devices.
1 Align the module using the upper and lower tongue-and-groove slots with the
adjacent module and slide forward in the direction of the arrow.
2 Move the module back along the tongue-and-groove slots until the bus
connectors on the MVI69 module and the adjacent module line up with each
other.
Vista de pagina 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 128 129

Comentarios a estos manuales

Sin comentarios