Prosoft-technology MVI69-DNP Manual de usuario descargar pdf (Pagina 67)

Diagnostics and Troubleshooting MVI69-DNP ♦ CompactLogix or MicroLogix Platform

DNP 3.0 Master/Slave Communication Module

ProSoft Technology, Inc. Page 67 of 129

November 3, 2008

Bit Description Value

11 0x0800

12 0x1000

13 0x2000

14 0x4000

15 0x8000

Correct any invalid data in the configuration for proper module operation. When

the configuration contains a valid parameter set, all the bits in the configuration

word will be clear. This does not indicate that the configuration is valid for the

user application. Make sure each parameter is set correctly for the specific

application.

If the APP, BP ACT and OK LEDs blink at a rate of every one-second, this

indicates a serious problem with the module. Call ProSoft Technology support to

arrange for repairs.

4.2.1 Clearing a Fault Condition

Typically, if the OK LED on the front of the module turns red for more than ten

seconds, a hardware problem has been detected in the module, or the program

has exited.

To clear the condition, follow these steps:

1 Turn off power to the rack

2 Remove the card from the rack

3 Verify that all jumpers are set correctly

4 If the module requires a Compact Flash card, verify that the card is installed

correctly

5 Re-insert the card in the rack and turn the power back on

6 Verify the configuration data being transferred to the module from the

CompactLogix or MicroLogix processor.

If the module's OK LED does not turn green, verify that the module is inserted

completely into the rack. If this does not cure the problem, contact ProSoft

Technology Support.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 128 129

Sin comentarios

Prosoft-technology MVI69-DNP Manual de usuario Pagina 67