Prosoft-technology MVI69-DNP Manual de usuario descargar pdf (Pagina 28)

MVI69-DNP ♦ CompactLogix or MicroLogix Platform Configuring the MVI69-DNP Module

DNP 3.0 Master/Slave Communication Module

Page 28 of 129 ProSoft Technology, Inc.

November 3, 2008

[Section]/Item Value Range Description

[IED Database] Database definition for DNP master port if utilized

Binary Inputs: 0 to 7680

points

Number of binary input points contained in the IED

database to transfer to the CompactLogix processor

and obtained from the attached IED units..

Analog Inputs: 0 to 480 points Number of analog input points contained in the IED

database to transfer to the CompactLogix processor

and obtained from the attached IED units..

Counters: 0 to 240 points Number of counter points contained in the IED

database to transfer to the CompactLogix processor

and obtained from the attached IED units..

Binary Outputs: 0 to 7680

points

Number of binary output points contained in the IED

database which are transferred from the CompactLogix

processor and used by the attached IED units..

Analog Outputs: 0 to 480 points Number of analog output points contained in the IED

database which are transferred from the CompactLogix

processor and used by the attached IED units..

[Section]/Item

Description

[DNP Master Slave List] Definition of the IED units to be interfaced with the

DNP master port if utilized

# This section stores information about each slave to be used by the master port.

# There must be an entry in this table for each node to be used in the command list.

# Two of the parameters in this list are coded values:

# Conf Mode ==> 0=Never, 1=Sometimes and 2=Always (select 0).

# Flags is bit coded as follows:

# Bit 0 (decimal 1) ==> Enable the slave

# Bit 1 (decimal 2) ==> Use Unsolicited messaging with this slave

# Bit 2 (decimal 4) ==> Use delay measurement with this slave

# Bit 3 (decimal 8) ==> Auto time synchronization enabled

# Node DL Conf Conf Conf App Rsp

# Address Mode Timeout Retry Timeout Flags

START

END

[Section]/Item

Description

[DNP Master Commands] Definition of the commands to be issued to the IED

units by the DNP master port.

# This section contains the list of commands to process on the master port.

# Node addresses present in the command list must have an entry in the

# [DNP Slave List]. Commands with nodes not present in the list will not be

# executed.

# 1 2 3 4 5 6 7 8 9 10

#Flags/ Node Data Data Cmd Device Point DNP DB IED DB Poll

#Enable Address Object Variation Func Address Count Address Address Interval

START

END

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 128 129

Comentarios a estos manuales

Sin comentarios

Prosoft-technology MVI69-DNP Manual de usuario Pagina 28

Comentarios a estos manuales

Relacionado con productos y manuales para Relé Prosoft-technology MVI69-DNP