Prosoft-technology 5201-MNET-101S Manual de usuario descargar pdf (Pagina 49)

IEC-101 Slave ♦ ProLinx Communication Gateway 101S Protocol Configuration

IEC 60870-5-101 v3 Slave (Firmware version 3.xx) Protocol Manual

ProSoft Technology, Inc. Page 49 of 159

August 6, 2010

2.17 [C_SE_NC_1]

This section defines the short-float setpoint database. This information is sourced

from the remote Master and is transferred to the database.

You can associate a command with a monitored single-point database value to

coordinate the command/monitor operation. You must enter the correct M

ONITOR

POINT # and MONITOR DB ADDRESS values in the table. If the REQUIRE SELECT

parameter is not set to zero, a select command must be received before an

execute command will be processed.

This section takes the following parameters:

 P

OINT #

 DB

ADDRESS

 M

ONITOR POINT #

 M

ONITOR DB ADDRESS

 R

EQUIRE SELECT

Each point consumes two words. The

DB ADDRESS value corresponds to the

double-word offset in the database.

The

DB ADDRESS should be located in a database area that is being constantly

moved from the Master to the gateway.

For additional information on how to set these parameters, see the Reference

chapter of this manual.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 158 159

Sin comentarios

Prosoft-technology 5201-MNET-101S Manual de usuario Pagina 49