
PS69-DPM ♦ CompactLogix or MicroLogix Platform Contents
PROFIBUS DPV1 Master User Manual
ProSoft Technology, Inc. Page 61 of 130
October 1, 2014
3.1.2 Input Array
Device Status Registers
The PS69-DPM module uses the first 4 bytes of the CPUs input area to transfer Device
Status Register information. The Device State Register contains information indicating the
modules communication status and command status. The CPUs input area mapping of this
information is shown below.
Handshake Acknowledge Bits
MSB := Module Status Bits
RDY (Ready)
When this bit is set, the module is operational. The RDY bit should always be set by the
module. If this bit is not set a system error has occurred and the communication between
controller and module is not possible.
RUN (Run)
When the RUN bit is set, the module is ready for communication. Otherwise an
initialization error or incorrect parameterization has occurred. Further diagnostic is
carried out with the PROSOFT.fdt (SYCON.net) configuration tool.
COM (Communication)
When this bit is set, the communication is started and the module is engaged in cyclic
data exchange with at least one of the connected Slaves.
HSA := Handshake Acknowledge Bits
SlvDiagCnf ,Slave Diag Confirmation
GlbCtrCnf , Global Control Confirmation
Comentarios a estos manuales