Prosoft-technology AN-X-AMX Manual de usuario descargar pdf (Pagina 13)

AN-X-AMXRIO Page

1. Select the Ethernet adapter that’s connected to the AN-X. In most cases there will be

just one Ethernet adapter in the computer. The AN-X must be on the same subnet as the

computer.

2. Enter the MAC address of the AN-X you are configuring. This is printed on the AN-X

label. It consists of six pairs of hexadecimal digits, separated by hyphens. In the

example above, it’s 00-0c-1a-00-00-0a.

If the AN-X is already online, you can obtain its MAC address using the Utilities/Locate

All AN-X Modules command.

3. Enter the IP address you intend the AN-X to use.

Step 2

In step 2, you choose a method of restarting AN-X to put it in boot mode.

The preferred method is to cycle power on the AN-X. Select the first option on the

screen and click the Next >> button.

The second method, useful if the AN-X in not easily accessible, is to send it a command

over Ethernet. The AN-X must be powered on and completely running for this method to

work. For example, if this is the first time you are configuring a new AN-X, allow

sufficient time for it to acquire an IP address from a DHCP server or to time out and use

its default IP address (about 3 minutes). Select the second option on the screen and click

the Next >> button.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 54 55

Sin comentarios

Prosoft-technology AN-X-AMX Manual de usuario Pagina 13