
ILX69-PBM ♦ CompactLogix or MicroLogix Platform Contents
PROFIBUS Master Communication Module User Manual
ProSoft Technology, Inc. Page 83 of 124
February 4, 2015
Slave Diagnostic
The Slave Diagnostic request is used to query the status of a slave by its address. This
request can be used to determine the general health of the slave device. The instruction
Request / Confirmation format is as follows.
ILX69PBM.CONTROL.SlaveDiagnostic.GetSlaveDiag.
Triggers the Get Slave Diagnostic command
0 = Requested from Master
1 = Requested from Slave
Message Status, see below
MSGStatus - Message Status
Message Status is available
Last message was transmitted with an error
ILX69PBM.CONTROL.SlaveDiagnostic.GetSlaveDiag.Response.
No response from slave or the station does not exist.
Slave is not in a ready state
Configuration fault detected
Extended diagnostics area is used
Unknown command is detected by the slave
Last parameterization telegram was faulty
Slave is controlled by another master
Slave must be parameterized
This bit remains active until all diagnostics data has been
retrieved from the slave
This bit is always set by the slave
Slave watchdog is activated
Comentarios a estos manuales