Prosoft-technology PLX81-EIP-61850 Manual de usuario descargar pdf (Pagina 11)

PLX8x-EIP-61850 ♦ Communication Gateway Start Here

Server to

IEC 61850 Client User Manual

ProSoft Technology, Inc. Page 11 of 167

July 2, 2015

1.4 Setting Jumpers

Jumper settings are located on the back of the module.

1.4.1 PLX81-EIP-61850

When the module is manufactured, the port selection jumpers are set to Mode 3.

You must set the jumpers to the correct position. The following diagram of the

back of the module describes the jumper settings.

Mode 3:

Setup Jumper: This is the top jumper. This must be jumpered when performing a

firmware upgrade or when downloading a configuration file to the module. For

normal operation, this jumper should be hung on only one pin (not jumpered).

Removing the jumper allows for better communications between the IEC and

EtherNet/IP driver and the jumper should be removed during running conditions.

Mode 2:

Default IP Jumper: This is the middle jumper. The default IP address of the

gateway is 192.168.0.250. Set this jumper to set the gateway's IP address back

to the default. For normal operation, this jumper should be hung on only one pin

(not jumpered).

Mode 1:

Reserved Jumper: This is the bottom jumper. It is reserved for internal ProSoft

Technology use only. For normal operation, this jumper should be hung on only

one pin (not jumpered).

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 166 167

Sin comentarios

Prosoft-technology PLX81-EIP-61850 Manual de usuario Pagina 11