ProSoft Technology inRA-x ILX34-AENWG Guia de preparacion descargar pdf (Pagina 18)

ILX34-AENWG ♦ POINT I/O Platform Procedures

Wireless Point I/O Adapter Setup Guide

Page 18 of 79 ProSoft Technology, Inc.

July 31, 2009

3.2.3 Configure the Wireless Access Point

Although the ILX34-AENWG can communicate with any 802.11b/g Access Point

radio, ProSoft Technology recommends the RadioLinx series Industrial

Broadband radios wherever performance and compatibility are required.

The following configuration steps are for the RLXIB-IHW. Use the examples in

these steps to configure your own Access Point to work with the ILX34-AENWG.

Configure the Master Radio (Required)

The following illustration shows an example configuration for a RadioLinx

Industrial Hotspot (Access Point) configured as a Master radio.

Note: The radio in this illustration is capable of transmitting at 5 GHz (802.11a) as well as 2.4 GHz

(802.11b/g). The radio in the ILX34-AENWG adapter supports only 2.4 GHz (802.11b/g).

In particular, note the following settings.

 Network SSID: All radios on the network must use the same Network SSID

In this example, the Network SSID is "Point_IO".

 Channel: All radios must use the same channel. In this example, the channel

is 8 (2447MHz).

 Encryption: All radios must use the same encryption settings. In this

example, the encryption type is WPA/WPA2-AES.

 Passphrase: All radios must use the same passphrase. For security reasons,

the passphrase field is replaced with asterisks. Make a note of the

passphrase before configuring additional radios.

Important: Take care to enter the passphrase on the ILX34-AENWG exactly as you entered it in

the Master radio.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 78 79

Sin comentarios

ProSoft Technology inRA-x ILX34-AENWG Guia de preparacion Pagina 18