ProSoft Technology inRA-x ILX34-AENWG Guia de preparacion descargar pdf (Pagina 31)

Procedures ILX34-AENWG ♦ POINT I/O Platform

Setup Guide Wireless Point I/O Adapter

ProSoft Technology, Inc. Page 31 of 79

July 31, 2009

Configure Chassis Size

The ILX34-AENWG requires configuration of its chassis size before you can

make any I/O connections. The default setting for the chassis size is 1 slot, which

represents the adapter by itself, and allows for no I/O.

You must set the chassis size to a number equaling 1 slot for the adapter plus 1

slot for each I/O module present in the adapter's backplane. For example, the

adapter plus 2 I/O modules uses a chassis size of 3. The adapter stores this

chassis size setting in non-volatile storage.

When the adapter's non-volatile chassis size does not match the actual number

of modules present on its backplane, the adapter does not make any I/O

connections and an error occurs.

1 In the Module Definition area of the General tab, click the C

HANGE button.

This action opens the M

ODULE DEFINITION dialog box.

2 Select the Chassis Size for your project from the dropdown list, and then

Click OK

to close the MODULE DEFINITION dialog box. In a later step, you will

verify the chassis size when you are online with the ILX34-AENWG.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 78 79

Sin comentarios

ProSoft Technology inRA-x ILX34-AENWG Guia de preparacion Pagina 31