Prosoft-technology 5204SE-MNET-PDPMV1 Manual de usuario descargar pdf (Pagina 139)

Reference 5204SE-MNET-PDPMV1 ♦ ProLinx Gateway

User Manual Modbus TCP/IP to PROFIBUS DP-V1 Pass-Through Master

ProSoft Technology, Inc. Page 139 of 235

December 22, 2009

Quantum MBP_MSTR TCP/IP Ethernet Error Codes

An error in an MSTR routine via TCP/IP Ethernet may produce one of the

following errors in the MSTR control block. The error code appears as:

Mmss

where: M is the high code

m is the low code

ss is a subcode

Hexadecimal Error Codes For TCP/IP Ethernet Message Errors:

Hex Error Code Meaning

1001 Abort by user

2001 An operation type that is not supported has been specified in the

control block

2002 One or more control block parameters were modified while the MSTR

element was active (this only applies to operations which require

several cycles for completion). Control block parameters my only be

modified in inactive MSTR components.

2003 Invalid value in the length field of the control block

2004 Invalid value in the offset field of the control block

2005 Invalid value in the length and offset fields of the control block

2006 Unauthorized data field on slave

2008 Unauthorized network routing path on slave

200E The control block is not assigned, or parts of the control block are

located outside of the %MW (4x) range.

3000 Generic Modbus failure code

30ss Exception response by Modbus slave

4001 Inconsistent response by Modbus slave

ss Hexadecimal Subcode in 30ss Error Code

Hex Error Subcode Meaning

01 Slave does not support requested operation

02 Non-existing slave registers were requested

03 An unauthorized data value was requested

05 Slave has accepted a lengthy program command

06 Function cannot currently be carried out: lengthy command running

07 Slave has rejected lengthy program command

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 234 235

Sin comentarios

Prosoft-technology 5204SE-MNET-PDPMV1 Manual de usuario Pagina 139