Prosoft-technology 5204SE-MNET-PDPMV1 Manual de usuario descargar pdf (Pagina 29)

Procedures 5204SE-MNET-PDPMV1 ♦ ProLinx Gateway

User Manual Modbus TCP/IP to PROFIBUS DP-V1 Pass-Through Master

ProSoft Technology, Inc. Page 29 of 235

December 22, 2009

6 Double click the S

LAVE icon to view the Slave properties dialog.

ProSoft Configuration Builder automatically assigns a PROFIBUS address to

each new slave. The slave address assignment begins at address 3 for the

first slave added to the network (addresses 0, 1, and 2 are reserved for use

with PROFIBUS Masters), and is incremented by 1 for each new slave added

to the network. You may, however, assign any address, 0-125 to any Master

or slave node as long as you do not assign the same address to more than

one device. You can change the address in the C

OMMON tab of the Slave

properties dialog box. ProSoft Configuration Builder will not allow you to

assign a PROFIBUS address that is already in use by another device on this

network.

Leave the remaining settings unchanged for now, and click OK

to close the

Slave properties dialog box.

7 Repeat steps 2 through 6 for all slaves you intend to place on the network.

8 When you are finished adding slaves, open the P

ROJECT menu and choose

XIT. Click YES to save the project and return to the PROFIBUS Master Setup

dialog box.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 234 235

Sin comentarios

Prosoft-technology 5204SE-MNET-PDPMV1 Manual de usuario Pagina 29