Prosoft-technology MVI71-DFNT Manual de usuario descargar pdf (Pagina 160)

Reference MVI71-DFNT ♦ PLC 5

User Manual EtherNet/IP Client/Server Communication Module

Page 160 of 175 ProSoft Technology, Inc.

February 3, 2011

Perform the following steps to set up your network.

Step 1- Configure the Pass-Through Server

The MVI71-DFNT Pass-Through Server connects a local computer serial port to

the module's Ethernet driver. Refer to the configuration file to configure the

following section:

[DF1 Pass-Through Server Port 1]

Enabled: Yes #Y=Use server, N=Do not use server

Service Port Number: 15000 #TCP service port for this server

Busy Timeout: 500 #Time to wait for not Busy (100-65535 milliseconds)

Baud Rate: 19200 #Baud rate for port 110-115200

Parity: None #N=None,O=Odd,E=Even,M=Mark,S=Space

Data Bits: 8 #5, 6, 7 or 8

Stop Bits: 1 #1 or 2

Select Y (or Yes) for the Enabled parameter and then configure each

communication parameter.

Step 2- Configure the Serial/IP Converter Software

Conversion software is required in order to convert serial data to TCP/IP format.

The software will select a serial port that is not being used and direct to it to an IP

address and port number (MVI71-DFNT Pass-Through Server). It is essential to

select the MVI71-DFNT IP address and the port number configured on the

previous step.

The serial communication parameters should also match the parameters

configured in the previous step.

Step 3- Configure a RS-232 driver at RS-LINX

Open the RS-LINX software and create a new RS-232 driver:

1 2 ... 155 156 157 158 159 160 161 162 163 164 165 ... 174 175

Sin comentarios

Prosoft-technology MVI71-DFNT Manual de usuario Pagina 160